Jump to content

Suggestion, switch to the arduino 2560adk for android

falc

By falc
in Coffee corner

 Share

Recommended Posts

falc

falc 6

Posted
Posted · Suggestion, switch to the arduino 2560adk for android

Just a suggestion but i think it would be good if we could use an arduino 2560adk board. This would open the door wide open to develop android apps. That way you can hook up a tablet and add a touchscreen interface.

But i think the pin layout is a little different

    • Link to post
    Share on other sites
    mr_seeker

    mr_seeker 0

    Posted
    Posted · Suggestion, switch to the arduino 2560adk for android

    Couple of warnings when using the arduino in combination with the ADK:

     


    • [*:3ly4qq9t]You cant use pin 7, 50, 51 and 52. Its used for communications.
      [*:3ly4qq9t]When you get a call, expect the machine to stop functioning.
      [*:3ly4qq9t]When your screensaver is active, the communication will stop.
      [*:3ly4qq9t]The ADK has softreset, so expect the machine to reboot itself every time you connect/disconnect it.

     

    Its just something to keep in the back of your mind ;)

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...