Jump to content
Ultimaker Community of 3D Printing Experts

Build plate cools down when print starts on Ultimaker 2+


Recommended Posts

Posted · Build plate cools down when print starts on Ultimaker 2+

Hi. I have problems with buildplate heating. It preheats well (I tried all range of temperatures from 60 to 115 C). It also keeps temperature well when it's raised. And it keeps temperature when extruder is hot. But after print begins buildplate temperature decreases to ambient temperature and corners begin to warp. When I put the print on pause buildplate temperature increases to working temperature again until I press resume.

I use Cura 3.2.1 but I don't think it's slicer problem. I unplugged heating contacts from buildplate and mainboard, cleaned everything with alcohol but it hasn't helped. Did anybody face such problem? Any advices?

 

  • Link to post
    Share on other sites
    Posted · Build plate cools down when print starts on Ultimaker 2+

    Are you using tinkermarlin?  It has a power budget feature which may be turning off your build plate.

     

    More likely you have a loose wire such that when the bed is down it's fine and when the bed is up the heater isn't making contact.  You can test this by sliding the bed up and down manually.

     

    Usually, the problem is right where the 2 larger wires connect to the heated bed.  Either you need to loosen the screws, stick the wires in again and retighten or slightly more likely - you need to reflow the solder that connects the terminals to the heated bed.  Are you an electrical engineer or do you have a friend who is one?  You could potentially ask your reseller for another heated bed if retightening the screws that hold the heater wires in doesn't help.

  • Link to post
    Share on other sites
    Posted · Build plate cools down when print starts on Ultimaker 2+

    I don't use other side firmware. I just updated my old one with Cura to Vers:_2.6.2   jul 4 2017

    I slided bed manually and found the problem is in bad connection.

    But there are no screws on the bed. So I'll try to change bed or wires. Thanks

     

    IMG_20180406_002814.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...