Jump to content
Ultimaker Community of 3D Printing Experts

UMO+ Where to Begin?


Recommended Posts

Posted · UMO+ Where to Begin?

I've just completed building my printer following the excellent instructions.

Now though I feel high and dry. The manual provides a link to the website for configuration and calibration.

It's not obviuos which version of Cura I should use. I installed Cura 3.

On first use it suggests I make some checks. the first page allows me to test the nozzle and bed temperatures and informs me that the limit switches have not been tested.

Then I move to levelling the plate and start the test. The plate is positioned several mms below the nozzle such that I can make any adjustements.

I've tried searching the forum and website  for a dummies guide but I've failed.

Has anybody a set of instructions on how to get started. It's a shame such a set are not included with the printer.

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...