Jump to content
Ultimaker Community of 3D Printing Experts

Cura 3.2/3.3 and Mark2 - ok?

Recommended Posts

Posted · Cura 3.2/3.3 and Mark2 - ok?

Hi all,


can you tell if the newest Cura versions run fine with Mark2?

Afair I have read that there were issues with the 3.x versions so I was not upgrading yet to save time & trouble.

Have there been issues at all? Are they fixed? 

I saw there is additional config files for Cura in the github package for Cura 3, is that all it needs?



  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 13 replies
    • Create New...