Jump to content
Ultimaker Community of 3D Printing Experts
n4pst3r3r

Z height wrong, might be cura

Recommended Posts

Hi everyone, 

 

I printed some card holders lately, like the one that can bee seen in the attached picture on the left hand side. On the right hand side is the same card holder, but printed in a 4x4 array with the same settings otherwise. 

 

Does anyone have an idea how this could have happened?

 

Slicer was Cura (that's why I'm asking in this forum), printer an Anet A8 with Marlin. 

The settings were pretty much the default ones, 8mm rim, 0.1mm layer height. At first I thought it could have been the adaptive layer height, has I had it switched on the first time it came out so badly, but the result was the same after switching it off. 

 

Any ideas are appreciated 🙂

IMG_20180530_182207.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!