Jump to content
Ultimaker Community of 3D Printing Experts

PP not in Ultimaker 2+ extended


Recommended Posts

Posted · PP not in Ultimaker 2+ extended

I'm about to change material on my ultimaker 2+ extended but just as i'm putting the material in the interface I see no option for PP. On this page https://ultimaker.com/en/products/ultimaker-2-plus  it's says it's not optimized for it and on this page https://ultimaker.com/en/resources/49799-material-compatibility?utm_source=cura&utm_medium=software&utm_campaign=resources it's says that it can ???? My firmware is up to date also. Do I choose a random material and change it right before printing?

  • Link to post
    Share on other sites
    Posted · PP not in Ultimaker 2+ extended

    Did you do a factory reset after updating your firmware? Sometimes new profiles don't show up after a firmware update unless you factory reset the printer. 

    PP should be fine for a UM2X+. It uses the same feeder as the UM3. 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...