Jump to content
Ultimaker Community of 3D Printing Experts

Cura simply not working after profile creation


Recommended Posts

  • 3 months later...
Posted (edited) · Cura simply not working after profile creation

@lfei and other Ultimaker people, there still seems to be a problem with the way Cura's saves/retrieves profiles. Not as bad as it used to be before 4.3.1 but it's still not working right. When you update a profile with current settings/overrides it saves most of the settings most of the time but it's not reliable as some settings may have changed randomly when that profile is loaded again. I still have to check them all the time because every now and again some value changes all by itself.

Tonight I had to interrupt my normal routine and print a small part in PLA using the recommended settings, and when I finished that job and continued with my "normal" work, I loaded my workhorse ASA profile. However suddenly it was unrecognizable. The following values were not as I saved them (I selected "discard" in case you were wondering.)

  • Layer height
  • Wall line count
  • Outer before inner walls
  • Z seam alignment
  • Infill density
  • Initial printing temperature
  • Final printing temperature
  • Retraction distance
  • Infill speed
  • Outer wall speed
  • Inner wall speed
  • Combing mode
  • Retract before outer wall
  • Enable print cooling
  • Build plate adhesion type
  • Dual Extrusion (all the settings there were different)
  • Slicing tolerance
  • Infill optimization
  • Enable coasting

NONE of the above settings were as I had saved them even though I've updated the profile bit by bit over the past few weeks to get it perfect. Now I have to re-do it all over again, just to re-do it again at some unexpected point in future.

 

Guys, my UM3 is not a toy, I'm trying to run a business here and can't afford to re-do stuff over and over again in Cura. Can you please help and sort this out, or if I'm misunderstanding the concept of profiles please explain it to me. The way I see it, if the grey star appears after I make a change, I have changed the profile and if I'm satisfied with my change I can update the profile and the star disappears, and next time I load the profile my settings will be back. If my understanding is correct, then I'm sad to say there is a bug and it's costing me time and sometimes filament if these changes happen and I don't catch them in time.

 

Edited by Patronus
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...