Jump to content
Ultimaker Community of 3D Printing Experts

Ultimaker 3 extended nozzle cover part broke off. Need help fixing it.

Recommended Posts

Ultimaker 3 extended nozzle cover part broke off. Need help fixing it.


Hello so my UM3 extended was printing just fine until the nozzle cover broke off and the plastic or rubber bit on the inside that holds nozzles split in two. I have gotten the cover back on but the nozzles have been having trouble with getting stuck or not retracting properly due to thDisplaying IMG_9358.JPGe damaged cover.


Is there any way I can fix this? Or get replacement parts?  Thank you for your time



Edited by l0l2d_l3yl20n

Share this post

Link to post
Share on other sites

Hi, in general the printer works also without this cover.

If you buy the maintenance kit, there are 5 spares:



you can also get only the silicone parts pretty cheap:


  • Like 1

Share this post

Link to post
Share on other sites



I haven’t found any kind of technical spare parts list. I usually keep the UM3 maintenance kit and the belt set in stock, to make sure to fix small issues just in time.

You could get the measurements by just measuring your printer ;)


On you concern with the tape: I’m printing since more than a year with one of my printers (UM3E) without the silicone cover. I’m only printing stuff that doesn’t need special bridging abilities or very high precision. So I don’t really care about the the airflow not being perfectly.

I haven’t made any other bad experiences with the lack ob the cover - but no guarantee ;)

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 121 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!