Jump to content
Ultimaker Community of 3D Printing Experts

Cura settings for infill

Recommended Posts

I can't figure out what I'm doing wrong here (I'm pretty new to this), but I keep getting this issue when printing.  I've tried it slow and normal speed, higher and lower temp, etc and can't seem to fix it.  Is there a setting I'm missing that is causing this? 


Share this post

Link to post
Share on other sites

Definitely going to a lower temp will not help as the plastic does not have enough heat to flow at this. Depending on what you used and what combination, you may have countered any effect in a negative way.


But, what slicer are you using?


When you say you chose slower,  I ask, slower what?


If you are using Cura, can you safe the project file as a ".curaporject.3mf" file and post it? Use "save project", not just "Save"..... I can take a look at it in your native format.

Share this post

Link to post
Share on other sites

Standard CURA settings are usually pretty spot-on, especially if you use UM materials.


Can you give us more information on what you're trying to do? What are you trying to print? What material are you using?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!