kmanstudios 1,120
2 hours ago, Abdu said:Tough PLA for a 0.25mm extruder.
There is the discrepancy between your experience and mine. I am using the 0.4 and 0.8 nozzle. I ahve not even tried the 0.25 I have on either my UM3E's or the S5.
Have you tried the TPLA on the UM3E as well?
Recommended Posts
Top Posters In This Topic
23
11
10
5
Popular Days
Jul 21
17
Jul 17
10
Jul 11
8
Jul 18
8
Top Posters In This Topic
Abdu 23 posts
kmanstudios 11 posts
SandervG 10 posts
gr5 5 posts
Popular Days
Jul 21 2018
17 posts
Jul 17 2018
10 posts
Jul 11 2018
8 posts
Jul 18 2018
8 posts
Popular Posts
thorsenrune
This printer is amazing. But it would be intelligent to skip bedprobing between small jobs (or if a job was cancelled) to save some time. Once the bed is probed one should think it would stay calibrat
gr5
Okay so here's how to disable active leveling on S3 or S5. But keep in mind that 1) This is not an approved operation by Ultimaker. If you are going to call customer service about something, p
WesleyE
This indeed not what would be expected. Would you be able to post your model and Cura settings? It is difficult to see only from the photo where it went wrong. We would love to research this. Did the
Posted Images
Abdu 1
okay.. so i did everything i could, but i am still unable to crack this. My Ultimaker S5 hasnt still been capable of beating my Ultimaker 3 with quality.
What i noticed when i watched closely, is that after some really nice looking layers, the extruder starts extruding dots of filaments instead of proper lines. and that just ruins it by making the surface coarse and cracky. i had kept a 21hr print and noticed this happen many times in between. Here is an image of it:
As you can see from the image, there is a band where there is less filament extruded.
It would be great if someone can provide me exact settings for Tough PLA for a 0.25mm extruder.
Am i missing out anything?
Link to post
Share on other sites