Jump to content
Ultimaker Community of 3D Printing Experts

U2 is not working with new Cura


brianl
 Share

Recommended Posts

Posted · U2 is not working with new Cura

I upgraded to the newer Cura after not printing since last fall from my pc.  One of the engineers, who is not here anymore, used several rolls of filament on the U2 we have and updated the firmware.  With the new Cura and a variety of filaments (all PLA) I can't get this to print well at all.  Foamy, jamming, blobs, not that the filament is feeding and not sticking to the bed, this just isn't feeding well.  I pulled the entire head apart and it is very clean but just does not work anymore.  Did something in a firmware update or Cura update allow for foamy prints?  I tried temps in 10 degree increments up to 260 and it just never flows.  Do I need to change the feeder device?  I am pulling the recommended specs from Cura.  Stock nozzle.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...