Jump to content
Ultimaker Community of 3D Printing Experts
Foulkn

Volumetric extruding.

Recommended Posts

I have been searching for a while now and cannot find a solution. 

I am using Cura 3.2.0 connecting to a Duet Wifi 1.21 with a coreXY and a diamond hotend. Every time i find some information on setting up to enable firmware retract I am told to set the GCode flavor to Reprap (volumetric). Do not have that as an option. I have Marlin (volumetric), but the duet does not like that flavor very well. I have read I can use Ulticode because its volumetric, but said I could not use Start GCode. But have tested that and it seems I still can. So not sure the version they were using.

 

Will there be any compability issues with using Ultimaker 2 flavor? 

Am I missing the RepRap (volumetric) option for some reason?

If anyone has a similar setup, mind sharing some settings?

 

Ed

Edited by Foulkn

Share this post


Link to post
Share on other sites

reprap volumetric I believe is identical to marlin volumetric.

 

With "volumetric" the extruder values are in mm^3 but with normal mode the extruder values are in mm (linear).  In normal mode, cura needs to know your filament diameter.  In volumetric mode the printer needs to know your filament diameter.

 

volumetric is something that Ultimaker invented so I'm quite surprised that the Duet would support such a thing.  The way Marlin (the printer firmware) detects whether a gcode file is in volumetric mode versus regular mode is it looks at the comments at the top of the gcode file and somewhere in there (no idea where) is a hint of some sort that Marlin looks for to decide.

 

I'm not sure of any good reason to use volumetric unless you swap between 1.75mm and 2.85mm filaments often and want to print the same part in both, one after the other and don't want to create 2 gcode files.  Does anyone ever do this?  I think not.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!