Jump to content
Ultimaker Community of 3D Printing Experts
TMicke

G-code for turning fans off after a given time

Recommended Posts

I figured it out my self

 

This is my ending script in Simplify3D:

 

G28 X0 ; home the X-axis

M84 ; disable motors

M140 S0 ; turn off bed

M106 S255 ; set fan to full speed

M109 S50 T0 ; wait until heater is 50°

M104 S0 ; turn off heaters

M107 ; turn off fan

 

Now after printing is done it sets the fans at full power until hotend reaches (cools down to) 50° then shuts of heater and fans.

 

I pretty sure my printer wont be ubducted by aliens if the fans are left on after printing is done, but I don't like things in general to be in motion or in use more than necessary 🙂 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!