UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
If you hover your mouse over the time it will show you how much time is spend on different step like infill, travel, retract... so it will give you an idea where to save time. You might wanna look at you speed to see if it's low, maybe your infill is set too high like if you have 100% infill it will use the top/bottom printing speed and it's often slower than infill speed.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Jeremi 4
If you hover your mouse over the time it will show you how much time is spend on different step like infill, travel, retract... so it will give you an idea where to save time. You might wanna look at you speed to see if it's low, maybe your infill is set too high like if you have 100% infill it will use the top/bottom printing speed and it's often slower than infill speed.
Link to post
Share on other sites
Craftylines 0
Hi, Thank you for yr response. I managed to get back to correct times by going back to the older version of Cura.
Link to post
Share on other sites