Jump to content
Ultimaker Community of 3D Printing Experts

Breakaway not breaking away


Recommended Posts

Posted · Breakaway not breaking away

Pretty much what the title implicates, the layers of Breakaway stick much better to the ABS than they do to themselves. Making removal of the supports, if at all possible, extremely difficult.

What can I change to make the ABS-Breakaway bond weaker in future prints? What techniques would help to remove the Breakaway from recent prints?

  • Link to post
    Share on other sites
    Posted · Breakaway not breaking away

    You can change the support Z distance. Increasing this will make the gap bigger between the support and the ABS. You can also reduce the interface density so not as much breakaway is in contact with the ABS.

    Just note that changing these too much will reduce the appearance of your bottom surface.

    I use some small electronics cutters to lift the thin strands off the prints.

    Are the support areas your trying to remove flat areas or quite complex shapes?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...