Jump to content
Ultimaker Community of 3D Printing Experts
nikakz

Config cura ABS and PLA for Core xy

Recommended Posts

Hi everyone, I'm a beginner in 3D printing and I bought a Hypercube Evolution model from Scott 3D, but I'm having a hard time configuring the Cure with it because I do not understand correctly how to make the correct configuration and here in Brazil we do not have a tutorial to help beginners. Could someone send me a config so I can try to adjust gradually and understand how I can do it? I need a starting point for a 300x300x300 XY core. Thank you and sorry for bad English. hug
 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 86 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!