Jump to content
Ultimaker Community of 3D Printing Experts
jungle2go

matching config files for hex files

Recommended Posts

I downloaded and  flashed Tinker-MarlinUltimaker2go-HBK-17.10.1.hex for my um2go to which I added a heated bed. Are there matching config  header files for this version?

I noticed that the heated bed is not powered continuously.  Probably because of the smaller power supply. In my situation i have separate power supply for the heated bed. I want to make a small change so that the bed is powered continuously.

Share this post


Link to post
Share on other sites

No need to change any code.  Go into the power budget settings and set your heated bed power to 1 watt and the software will realize it can keep the bed on full power even when the nozzle is on full power.  Or alternatively set the power budget to 255.  Again the software will realize there is no need to limit power.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!