ABS is quite difficult to print. Have you printed it before? Do you have a heated bed? This video will tell you the tricks to get it to stick well. Very well. But without a heated bed it's going to be very hard if not impossible. I guess my advice is: don't print ABS. It was the first popular material back in the day for 3d printing but we moved on a long time ago. PLA is the easiest to print. If you need something that can withstand higher temps then try nGen/PET/CPE.
Recommended Posts
Nicolinux 288
Hi,
which version of Cura do you use? If you use Cura 3.4.1 and still have installed the former version then try the old verion of Cura just to rule out a software related problem.
Link to post
Share on other sites