Jump to content
Ultimaker Community of 3D Printing Experts

UM S5 active levelling


Recommended Posts

Posted · UM S5 active levelling

Hi all,

 is there a way to start the active levelling on the S5? (Other than starting a print job and the abort it)?

I haven't found it in the menu ... (I would like to have it though, to check a new manual levelling.

 

In the troubleshooting section of the UM website it says ... " Restart the active leveling process. " and " After this, you can start the active leveling again." - But I don't know how .

Thanks - Yvonne

 

 

 

  • Link to post
    Share on other sites
    Posted · UM S5 active levelling

    I did not find a way to start it manually, so either I overlooked it or it is not available through the menu.

     

    But why do you need it? I find that leveling in general is seldomly needed (except if you remove the glass plate after every print).

    • Thanks 1
    Link to post
    Share on other sites
    Posted · UM S5 active levelling

    Yes  ...

     

    you're probably right and I only miss it much,beacuse it was there before .

     

    I use it a lot when I train new users on the UM and let the perform a manual levelling, to check afterwards.

     

    But in real life - you re right - its not so often needed - ?

     

    Nevertheless, thanks for looking it up !

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...