Jump to content
Ultimaker Community of 3D Printing Experts
engr

Max temp error on the build plate (ER14)

Recommended Posts

Hi,

 

I haven't experienced this error personally but according to the help text the next step would be to contact your reseller.

Before you do that, it might be worth a try to update the firmware to the latest version and reset to factory settings. If the board is not damaged, then a simple reset might help.

Share this post


Link to post
Share on other sites

Hi @engr,

 

This is an "intermittent" open connection between the bed temp sensor and the electronic board (located underside the printer). If this happen the input signal go hi up to 5 VDC and showing max temperature, so printer is halted!

You can test this by just start your printer and warm up you heat bed, say 60 Deg Celsius,

then try to move the heat bed say half way up. Then just move the cable coming from the heat bed going to the inner left corner. Just move it up and down gently to see if there is some wiring problem, close to the corner and close to the bed is the weak point of such arrangement (but good to check first). Ofc. monitor temp when doing this. Now try to variate the temp slowly + - 5 Deg, just to see if this is related to temperature variation.

Second check that the bed temp connector is properly installed.

Since this is an intermittent problem, it might also be the temp sensor on the heat bed that's the problem. Actually has happen a few times.. This latter is more complicated to correct. 

 

Thanks

Regards

Torgeir.  

 

 

 

 

Share this post


Link to post
Share on other sites

Replacing the thermistor (temperature sensor) seems to have fixed the problem.

If you know how to solder and replace SMD components, it's the PT100 component on the bed heater (see this site https://fbrc8.zendesk.com/hc/en-us/articles/208281963-Heated-Bed-Plate ) and we used this component https://www.digikey.com/product-detail/en/heraeus-sensor-technology-usa/32207605/1759-1009-1-ND/6677788 [specs 100 Ohms RTD Platinum ±0.3% ±3850ppm/°C -50°C ~ 130°C 0805 ].

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!