PLA as support for nylon?

[JohnInOttawa 104]

Just curious if this is a workable option.  I have a piece that I would rather not use PVA for support if I can help it.  Just not sure if PLA will work and what I might get in terms of interface (adhesion, removal, print quality).

 

Thanks in advance!
 

John

[Nicolinux 288]

According to the compatibility chart from Ultimaker, this combination has not been tested:

https://ultimaker.com/en/resources/49799-material-compatibility

 

But you could start a small test print and see how it behaves.

[JohnInOttawa 104]

That sounds like a good plan.  Thanks!

John