Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have never used a CR10, but the first thing that comes to mind is that the consistency of the temperature sensor on these Chinese machines may not be to good, meaning that with the same gcode one machine may be printing a lot hotter than the other. You probably need to dial the 2th machine in separately. Do some tests until you find comparable results. Sounds like you need to print a bit colder on the newest machine.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
ultiarjan 1,215
I have never used a CR10, but the first thing that comes to mind is that the consistency of the temperature sensor on these Chinese machines may not be to good, meaning that with the same gcode one machine may be printing a lot hotter than the other. You probably need to dial the 2th machine in separately. Do some tests until you find comparable results. Sounds like you need to print a bit colder on the newest machine.
Link to post
Share on other sites