Cura modifies model

[Maarten035 0]

Dear all, 

I became pretty frustrated when I tried to slice my bed leveleling test square. it is a 50 by 50 mm modeled in fusion, extruded to my initial layer height (.3 mm), and exported as .STL. When I open the file in Cura (using 3.4.1) it shows normally in the solid view. Then when I slice it and go to layer view it makes it into some rectangle with a kind of staircase layering. also the skirt is off. The video should be pretty clear. Other models I load into cura slice perfectly normal. So if this is a problem with the .STL, does anyone know what it might be? Thanks to anyone taking the time to reply. 

Regards, 

Maarten

Video: https://www.youtube.com/watch?v=Y4ASepGLzL0&feature=youtu.be

[nallath 1,117]

Err. That is weird. What do you see if you look at the model in xray mode? Could you try and run the model through a model fixing tool? 

[kmanstudios 1,120]

There is no way to see what is wrong with the STL unless you upload it to be checked. I would be happy to do so.

Edited September 10, 2018 by kmanstudios

[Maarten035 0]

Had a few things coming in between but anyway I got simplify3d and the issue is gone. thanks for the help.