Introducing Ultimaker Cura 3.5 | Beta

[boelle 1]

ahhh

 

google found this post for me: 

now i just need to figure how to make it remove: M82 ;absolute extrusion mode

 

is that possible or can the search and replace plugin only replace?

 

 

[boelle 1]

when i try search and replce with boundry arround M104 S0 it of course removes it from all lines so that my own switch off lines are also altered

 

i tried to google for how to do an precise match but i could not figure it

[Link 34]

Any idea when this will be made into an official release ?

[rburema 26]

@Link Should be later today!

[ahoeben 1,986]

"Soon"

 

Could be today, could be tomorrow. Could be next week too. Not saturday or sunday though, probably not friday.

[Link 34]

Ok, thanks 

[Link 34]

23 minutes ago, rburema said:

@Link Should be later today!

 

Excellent ! Thanks 

[SandervG 1,521]

Hi everyone, just wanted to let you know that we just released Ultimaker Cura 3.5 Beta. If you're interested, you can read more about it here (and download it too) ?

[boelle 1]

i'm confused, i allready have 3.5 beta so was it a type error?

 

and have i posted the wrong place since no one are able to tell me where cura gets the extra M104 S0 and M104 S0

 

[rburema 26]

@boelle This thread is about the 3.5-BETA release, but these last few messages are about the 3.5 (final) release, since people that downloaded the beta will probably also be interested in the full release.

[boelle 1]

oki, where would my questions have a bigger chance for getting an answer?

 

i have posted one other thread but no luck there either

 

otherwise i can only say thumbs up to the software, it has come a long way since i used it last time. I'm just a control freak when it comes to how the code is exported

[Guest maht]

We've just released a new beta onto the website. More info here:

 

[phantom 17]

On 9/25/2018 at 8:56 AM, ghostkeeper said:

I did a performance test on that 3.5 file using Callgrind and got this result: http://dulek.net/work/3.5-beta-callgrind.out.3886

 

This seems to point to this change: https://github.com/Ultimaker/CuraEngine/pull/791

We'll continue discussion there.

 

@Ghostkeeper,

 

I posted the same a few days back for cura 3.6, as the problem seems to persist. Do jou know if this will be resolved in the future?

 

Greetz Phantom

Edited November 29, 2018 by phantom
typo

[ghostkeeper 105]

We did some things to improve that, which should be released in 4.0.

[phantom 17]

1 hour ago, ghostkeeper said:

We did some things to improve that, which should be released in 4.0.

 

Great, thanks so much, i'll be looking forward to it !