Jump to content
Ultimaker Community of 3D Printing Experts

Netfabb profiles


mastory

Recommended Posts

Posted · Netfabb profiles

I believe I corrupted one of my netfabb material profiles. Is there someplace I can download the profiles that came with my software installation (recent). I believe these are credited to have been developed by Paul Candler and Florian Horsch. Is there a means to reset them to their 'defaults'? Not sure that defaults exist for the profiles...

Should I just re-install? I have only just tried (unsuccessfully so far) to use the software. Also, I think I read there is a new release just around the corner.

Thanks,

Matt

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...