Jump to content
Ultimaker Community of 3D Printing Experts
ichimo

Stripping on Raft???

Recommended Posts

What are the causes for stripping?  I only know about retraction, clogging, and being too close to the bed... but, I leveled the bed each go, turned off retraction, and checked to make sure the filament flowed properly before the print.  Is there something else I'm missing..?  The printer slowly starts making clicking noises and flat out stops extruding during the raft and there isn't any retraction or travel during the very first layer so I'm completely at a loss now!  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!