Jump to content
Ultimaker Community of 3D Printing Experts

Hotspot progression!


Recommended Posts

Posted · Hotspot progression!

When i try to set up a hot spot it just sits on "Printer is creating a wifi hotspot. this may take a minute." i left it sitting on that for a few hours while i was at work. Ive tried factory resetting it. unplugging it and letting it sit unplugged. it allowed me to connect at first, it created a hotspot i connected it to my wifi and updated the firmware. after this it wouldnt allow me to connect to it. so i tried factory resetting it and trying to setup a new hotspot and ive been stuck since.

  • Link to post
    Share on other sites
    Posted · Hotspot progression!

    There are two work-arounds: update with an USB stick and installation of the testing version and the again of the stable version. The first one is probably safer.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...