Bug in Bridge settings in 3.5.1

[Link 34]

There is a bug in that when you select 'bridge has multiple layers' this has no affect, essentially the bridge print Gcode is as though this option is always selected.

 

You cannot for example change the fact that the fan turns off on the second layer (even if you set it to stay off it still turns off. I have checked the Gcode and its is identical with and without this setting enabled.

 

 

[burtoogle 513]

Hi @Link, please attach the project file and I will investigate. Thanks.

[Link 34]

thanks

 

UM2_bridge-torture-test_50mm.3mf

[burtoogle 513]

Thanks for the file but, unfortunately, it causes my Cura to crash. I think it's something to do with the profile. Could you please create another one based on a non-custom profile?

[Link 34]

 

 

standard profileUM2_bridge-torture-test_50mm.3mf

Edited October 17, 2018 by Link

[burtoogle 513]

Thanks for that second project file, I could load that and verify the bug. I don't know how it got to be broken! Anyway, I will create a fix which should be in the next release. Sorry for the inconvenience.

[Link 34]

Thanks !, I don’t think it was your fault ?. 

[Link 34]

On 10/17/2018 at 7:55 PM, smartavionics said:

Thanks for that second project file, I could load that and verify the bug. I don't know how it got to be broken! Anyway, I will create a fix which should be in the next release. Sorry for the inconvenience.

 

hi @smartavionics did this make it into 3.6 ?

[burtoogle 513]

Hi @Link. Yes, I believe it did.