I installed today my new Bondtech extruder on the Ultimaker 2GO, and primarily it is working fine - first test print is currently running.
But I am not sure if the position of the extruder is optimal. The extruder on the UM2 is normally on the right side (back view) and then the Bondtech extruder is on the same position as the old one and the stepper motor come out a little bit on the right side.
On the UM2Go I have to mount the extruder on the left side, so the motor is
I was lazy the last days, but could finally finish my upgrade project.
Thanks again to @ultiarjan for his great idea and for his mount. I modified the holder and cut off the parts that are not needed for the UM2GO and it works great. I can access the feeder easily and could load and change material without any problems.
Additionally, I want to have to spool holder also on the side, because of the better handling and the "natural" way the filament is bent. An