Jump to content
Ultimaker Community of 3D Printing Experts
basteluwe

UMO+ controller shows nonsense, print stopps

Recommended Posts

Hi Guys,

after some days of hard and perfect work recently, my printer unfortunately failed today.

I was printing a 3h job in PLA when after about 75% suddenly the display of my UMO+ controller started to show random symbols and even some nonsense clutter. Short after I noticed that, it stopped printing completely and the head moved to home-position (X,Y).

I use Cura 3.5.1 and have just after that fault updated the UMO-firmware to the actual version (March, 2018). At present I run the same print again while crossing my fingers.

Any ideas as to what can cause a fault like that?

 

Regards from Germany,

Uwe

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!