Jump to content
Ultimaker Community of 3D Printing Experts

Another Camera issue UM3/cura


RubberRudder
 Share

Recommended Posts

Posted · Another Camera issue UM3/cura

UM3, camera blank after replacing wifi card. Can connect and send prints, but no video. Monitor flashes about every 2 seconds from "grey available" to "blue with the progress bar.

Thanks for looking!
Firmware is latest, Cura 3.6 beta.

  • Link to post
    Share on other sites

    Posted · Another Camera issue UM3/cura

     Paste this address in your browser to verify http://192.168.0.105:8080/?action=stream.
    Run Cura connect.

    If the wifi is working and the camera runs in a browser it's a cura configuration conflict, if not then guess like I do and replace camera hardware. 🙂

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...