Jump to content
Ultimaker Community of 3D Printing Experts

Cura Ultimaker 3.6 problem with layer view visualization


Nattien
 Share

Recommended Posts

Posted · Cura Ultimaker 3.6 problem with layer view visualization

Hi all,

 

I have problem with layer view visualization in Cura (not just in 3.6 but also older), see picture below. Is somebody know what can be source of this problem?layer_visualization.thumb.JPG.99cc69e7b7ecb2a4899e936b8b7b90b9.JPG

Best regards,

 

Nattien

  • Link to post
    Share on other sites

    Posted · Cura Ultimaker 3.6 problem with layer view visualization

    Perhaps you could explain what it is you have an issue with?

     

    Your layer view is in "Compatibility mode". For the more advanced layer view, you need a GPU that supports OpenGL 4.1. If your GPU does not support this, it switches to this "Compatibility mode" which only requires OpenGL 2.

  • Link to post
    Share on other sites

    Posted · Cura Ultimaker 3.6 problem with layer view visualization
    6 minutes ago, ahoeben said:

    Perhaps you could explain what it is you have an issue with?

     

    Your layer view is in "Compatibility mode". For the more advanced layer view, you need a GPU that supports OpenGL 4.1. If your GPU does not support this, it switches to this "Compatibility mode" which only requires OpenGL 2.

    I am understand. My GPU is support OpenGL 3.2. Thank you for your explanation.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...