Jump to content
Ultimaker Community of 3D Printing Experts

We made a little show about 3D Printing & our Ultimaker


darkflame

Recommended Posts

Posted · We made a little show about 3D Printing & our Ultimaker

Ok, its not exactly a video of a model...but I just finished editing and uploading a little show about 3d Printing in general featuring our Ultimaker;

randomreviewshow.com

(Episode 9; 3D Printing at the top)

 

Its a bit silly, and already outdated (I should have mentioned the Ultimaker add-on for dual extrusion), but I thought some people here might enjoy it.

 

I'll upload the models I made for the episode soon. Not sure where the best place these days is though. Thingyverse is falling out of fashion a bit ;)

 

Our Ultimaker started playing up just after we got the last shots filmed, so we were a bit lucky - we will also post a gallery of our stuff when we are running again :)

 

Anyway, thanks for listening, and I hope those that try our show enjoy it!

 

-Thomas

 

ps. Hope this doesnt seem spammy....seemed like the most fitting forum to put it in.

 

  • Link to post
    Share on other sites
    • 2 weeks later...
    Posted · We made a little show about 3D Printing & our Ultimaker

    Thanks. :) I quite agree. Awareness of 3d printing is now pretty mainstream.....but there's still a lot of miss-conceptions out there.

    Anyway...here's a gallery of what we have made so far;

    http://www.randomreviewshow.com/extras/3dPrintedGallery/3DPrintGallery.html

    Once we polished the models, we will post them online.

     

    This is probably our best yet:

    Kangle2.jpg

     

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...