Jump to content
ScarletImpaler

UM2+E jamming mid print with .25 nozzle.

Recommended Posts

Posted · UM2+E jamming mid print with .25 nozzle.

There is probably something simple I'm missing, but I've already tried Googling, but that hasn't given me much. 

I've used the stock .25 nozzle a few times before, but they always have been relatively small and quick prints, no more than a few hours, and .2 layer height. 

Now, I'm printing a pretty intricate and delicate model that needs a .25 nozzle and to print at .1 layer height, and even with a UM2, I feel like I need to print extremely slow. Every print attempt jammed at a random point. The kind "jam" where its not really jamming, and the edge of the filament, when pulled out, is thicker and kind of flat. 

I read that going too slow with a small nozzle can cause this problem, but it jammed at my last attempt at 45mm/s. I previously tried 15mm/s and 30mm/s. The print going at 45mm/s got the furthest along. I'm just too afraid to go any faster. The model is a female character figure with a thin skirt that flares out that needs lots of support for (I did everything I can to thicken the skirt area in Blender). 

Is there something I'm missing, or am I thinking too hard into this and just should increase the speed? Thanks! 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!