[BUG] Cura 3.6 firmware update on UMO+

[jeffsjunior 0]

I was looking for a place to report a bug, but I couldn't find anywhere so I created a topic. If that is wrong, tell me where to post.

 

Everytime I update Cura I also update the firmware of my printer, the last one I used was the Cura 3.4 and the firmware was alright on my UMO+ printer.

Today I updated to the new cura (Cura 3.6) and when I uploaded the firmware for my UMO+, it stopped working and became unresponsive.

Then, I reinstalled the old Cura 15... and now it works again.

 

Just to make sure it wasn't a bug, I uploaded the firmware again from Cura 3.6 and the same problem happened.

In conclusion, right now I am using the firmware from the older cura because the new one is problematic.

 

[ahoeben 1,849]

It was reported already here: