Jump to content
Ultimaker Community of 3D Printing Experts
pelleS

Massive instead of infill, how?

Recommended Posts

Is there a way to not get infill but instead massive?

I'm printing what basically is a piece of tube, 27mm outer diameter and 4mm wall thickness.

Even if I set 100% infill it prints a (very tight ofc) pattern "inside" the walls.

Is there a setting for "massive" or perhaps a work-around that accomplishes the same effect?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 0 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!