Jump to content
Ultimaker Community of 3D Printing Experts
lospo

infill a bottom part of my mini

Recommended Posts

HI,

 

as you can see in the image until layer 16 it is all ok, but layer 17 is too much surface and the quality is not good.

 

Can specify in cura that i want that kind of infill in the first 16 layers?

The original file is form heroforge the blue part is a raft made by cura.

 

Thanks!

layers.jpg

Share this post


Link to post
Share on other sites

It sounds like maybe the model is supposed to be hollow for the first 16 layers.

 

Although maybe it's just a bad model.  You can repair bad models most easily by passing them through the netfabb free repair service (you have to create an account):

https://service.netfabb.com/login.php

 

Or if you are lucky you can just go into Cura "mesh fixes" and play with each of those.  One of those might fix the problem.  But many of these will fill in areas that you want to be open so check carefully in layer view before printing.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!