I can only see the model files and not the Cura profile!
The pictures look a bit like some of my failed prints when "enable gradual infill" if its one, so try and turn it off, if on. This setting fucks up my S5 more then anything. (maybe it has changed in later Cura versions)
And like mentioned before the print temperature looks way to hot.
(dont know if there can be a setting overriding your custom set temperature?)
Recommended Posts
liba 0
HI 😉
@yellowshark
I lost the file🙊,
but I think I had al these settings.
It was one print like in the files attached.
Liba;)
Test UM.zip
Edited by libaLink to post
Share on other sites