Jump to content
Ultimaker Community of 3D Printing Experts

UM S5 - Material blob on top layer

Recommended Posts

When finishing a print, our UM S5 "pauses" for a short time after the last move, and only then lowers the build platform. This has the effect of nearly always producing a blob of material on top of the print (and sometimes also a melted area around the last nozzle contact point), which for some prints is quite difficult to remove cleanly. My Anycubic i3 Mega at home suffers much less from this problem, so I would think that the problem should be solvable with the S5 also.


Does any of you have experience with this?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!