Jump to content
Ultimaker Community of 3D Printing Experts
Miguel Garcia

Finalizar GCode

Recommended Posts

Ayuda, Hola buenas, estoy usando Cura 3.6.0  (y también lo he probado en 4.0.0 BETA y me pasa lo mismo), y en preferencias, configurar cura, impresoras, ajustes de la maquina,  tengo el M104 en S208 y cuando se termina la pieza no queda el extrusor a esa temperatura (se va a 0,  aun corrigiendo el GCoder como Imagen 2 ) si alguien me puede indicar donde tengo el fallo lo agradezco, 

(El M140 que es el de la cama me va perfecto y queda calentando cuando termina la pieza)


Adjunto imagenes


Muchas Gracias.


Saludos. y Felices Fiestas


ajuste de maquina.JPG

GCoder Prusa.JPG

Edited by Miguel Garcia

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 95 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!