You are welcome! 🙂
-
Our picks
-
Special introduction: Ultimaker Cura engine improvements with Arachne alpha
SandervG posted a topic in Ultimaker Cura,
We don't often release an alpha version of Ultimaker Cura... So what's different this time? This Alpha contains such a huge slicing engine overhaul that we really need your help!-
-
- 7 replies
Picked By
SandervG, -
-
Ultimaker Innovators list 2020
SandervG posted a topic in Official news,
We wish to celebrate and honor the innovators that push forward the field, technology and world. We opted to not present it as a competition or ranked list. Every innovator has earned his spot on that list in their own way. We also look at the 3D printing industry as a whole and not limit the list to those only using Ultimaker.-
-
- 3 replies
Picked By
SandervG, -
-
Recommended Posts
Smithy 752
Hi
looks like you have changed the pattern "Bottom Pattern Initial Layer" and/or "Top/Bottom Pattern" under Shell settings from Line to Concentric.
You can change it back manually (search for "pattern" in the search field if you don't see the setting) or just reselect one of the default profiles, then everything should be fine again.
Link to post
Share on other sites
tom356 0
thank you//
Link to post
Share on other sites