Jump to content
Ultimaker Community of 3D Printing Experts

Setting up origin offset/disallowed area

Recommended Posts

i think i found the plugin you are talking about, it only does z-axis, i need on the x-axis,
you see, if i configure cura to print with both heads my build size get's reduced in the firmware on the printer from 322x250(single head) to 270x250(dual head) and "home" position is the same while total buildplate size is 374x250 and add another 5mm gap on each side from nozzle to the edge of the buildplate when it's homed. so i need to figure out how i can make in total 62mm on each side of buildplate(x-axis) to be limited to "travel only".

Edited by sint_vaffel

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!