Trouble with infill pattern

[Leoboghozian 0]

Hello everyone,

 

I hope that all is well. Recently I have been facing infill problems with my 3D prints on the Ultimaker 2+. I'm not sure why the printer is unable to finish the infill patterns. If you look at the pictures attached to this, you'll see that some of the grind lines are not complete. From the right to left, I have changed the speeds for each print to improve the quality but the infill problem keeps showing up, I'm unable to figure out why. Any help/suggestions will be appreciated. 

 

 

My last setting:

 

Software: Ultimaker Cura 3.6

Material: PLA 230 C

 

(Quality)

Nozzle: 0.4 mm

Layer Height: .18 mm

Initial Layer Height: .18 mm

Line Width: .35 mm

 

(Shell)

Wall Thickness: 1.2 mm

Wall Line Count: 3 mm

Top/Bottom Thickness: .8 mm

Top Thickness: .8 mm

 

(Infill)

Infill Density: 20%

Infill Line Distance: 5.25 mm

Infill Pattern: Grid/Triangle

 

(Material)

Initial Layer Flow: 100%

Retraction Min. Travel: 0.8 mm

 

(Speed)

Print Speed: 40 mm/s

Infill Speed: 30 mm/s

Wall Speed: 30 mm/s

Outer Wall Speed: 30 mm/s

Inner Wall Speed: 30 mm/s

Top/Bottom Speed: 30 mm/s

Travel Speed: 40 mm/s

Initial Layer Speed: 30 mm/s

Initial Layer Travel Speed: 30 mm/s

 

 

 

Edited January 6, 2019 by Leoboghozian

[Smithy 1,141]

Which PLA are you using, because 230° C for PLA seems quite high.

Your print looks overall not really good, so I guess you have probably a problem with your Extrusion (Feeder, Bowden Tube, Teflon coupler, clogged nozzle) and/or your material brand is not the best (printing with cheap PLA can be terrible).