Jump to content
Ultimaker Community of 3D Printing Experts
Leoboghozian

Trouble with infill pattern

Recommended Posts

Hello everyone,

 

I hope that all is well. Recently I have been facing infill problems with my 3D prints on the Ultimaker 2+. I'm not sure why the printer is unable to finish the infill patterns. If you look at the pictures attached to this, you'll see that some of the grind lines are not complete. From the right to left, I have changed the speeds for each print to improve the quality but the infill problem keeps showing up, I'm unable to figure out why. Any help/suggestions will be appreciated. 

 

20190106_135606.thumb.jpg.1526e6df58c4133a16fbb8d8c8c7ac9a.jpg20190106_135629.thumb.jpg.8064b1b280028224c8c51953bc72118d.jpg

 

My last setting:

 

Software: Ultimaker Cura 3.6

Material: PLA 230 C

 

(Quality)

Nozzle: 0.4 mm

Layer Height: .18 mm

Initial Layer Height: .18 mm

Line Width: .35 mm

 

(Shell)

Wall Thickness: 1.2 mm

Wall Line Count: 3 mm

Top/Bottom Thickness: .8 mm

Top Thickness: .8 mm

 

(Infill)

Infill Density: 20%

Infill Line Distance: 5.25 mm

Infill Pattern: Grid/Triangle

 

(Material)

Initial Layer Flow: 100%

Retraction Min. Travel: 0.8 mm

 

(Speed)

Print Speed: 40 mm/s

Infill Speed: 30 mm/s

Wall Speed: 30 mm/s

Outer Wall Speed: 30 mm/s

Inner Wall Speed: 30 mm/s

Top/Bottom Speed: 30 mm/s

Travel Speed: 40 mm/s

Initial Layer Speed: 30 mm/s

Initial Layer Travel Speed: 30 mm/s

 

 

 

Edited by Leoboghozian

Share this post


Link to post
Share on other sites

Which PLA are you using, because 230° C for PLA seems quite high.

Your print looks overall not really good, so I guess you have probably a problem with your Extrusion (Feeder, Bowden Tube, Teflon coupler, clogged nozzle) and/or your material brand is not the best (printing with cheap PLA can be terrible).

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!