Tolerance Test
Hi Ultimaker Community,
I got a new UltimakerS5 a few weeks a go and while it is printing great I was a bit disapointed; I was expecting very precise dimensional prints...
I have listened to so many Youtube videos and found one on MakerMuse channel very interesting where Angus showed a tolerance/gap test. I just print my own tolerance test. I was expecting getting good results up to 0,2mm. Unfortunately, only the 0,5mm succeed (0,4mm & 0,3mm failed).
Is there a
Hi
the recommended settings are not the best for dimensional accuracy.
Try these additional settings to the recommended ones
Slicing Tolerance = Exclude
Combing Mode = off
Print Jerk = 20
Print Speed = 35 (set all other speed values, except travel also to 35, should be 6 values)
Outer before Inner Walls = Checked
Horizontal Expansion = -0.03
Initial Layer Horizontal Expansion = -0.2
