Jump to content
Hickman09

UMS5 HOME SWITCH CALI

Recommended Posts

Posted · UMS5 HOME SWITCH CALI

My home switch works during calibration and finds correct position to flip switch.

 

But anytime the home switch tries to find the correct position after that it will not work. 

 

I've updated, restarted, checked belts, factory reset. 

 

My process: Home switch calibration - works

                     XY Calibration- Home switch goes to flip switch and does not find home switch position. So then i go back to Home switch calibration and redo that step. Again it works but this step will not. 

 

Not sure whats going on....

 

 

 

 

Share this post


Link to post
Share on other sites
Posted · UMS5 HOME SWITCH CALI

You should also check if ALL pulleys are tight on the axles. Use the Torx screwdriver and tighten the setscrews on the pulleys.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!