Jump to content
Ultimaker Community of 3D Printing Experts

Strange ripples at the end and start of each layer


Nick__Mad
 Share

Recommended Posts

Posted · Strange ripples at the end and start of each layer

Could someone please remind me how to get rid of these artifacts? I remember that there is some sort of setting in Cura that addresses this particular issue but I can't quite remember which one.

In case its hard to see in the photos there are some odd artifacts that are created when the printhead finishes and starts drawing layers.

 

photo_2019-01-23_17-17-33.thumb.jpg.0c22c429649ce23aba91ac04dfbe7d72.jpgphoto_2019-01-23_17-17-34.thumb.jpg.50e806d0cfa7e27ca8c8c990bac46406.jpgphoto_2019-01-23_17-17-41.thumb.jpg.4f2e74520d4025e1f36e1f03b3430150.jpg

 

  • Link to post
    Share on other sites

    Posted · Strange ripples at the end and start of each layer

    I'm pretty sure it's the speed change.  Set the infill/inner/outer shell speeds all to the same speed and I think it will mostly go away.  When it starts the outer shell it typically drops the speed in half and so you get brief overextrusion as the pressure is equalized for faster printing and then it suddenly slows down.

     

     

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...