Jump to content
Stenrik

Co-Polyester + PVA?

Recommended Posts

Posted (edited) · Co-Polyester + PVA?

I was planning to print with some ColorFabb transparent Co-Polyester from on my Ultimaker 3.  The hope was that I could use it with Ultimaker brand PVA support material in the 2nd head. 

 

However, the Co-polyester's processing temp is 220-240 degrees C.  I know that PVA will not support materials with significantly higher printing temps, but this seems like a grey zone.

 

Also, just saw this on Ultlimaker's site:

"PVA is only supported on the Ultimaker 3 and is currently optimized to serve as a support structure for either PLA or Nylon."

 

This suggests that there may be a problem combining these materials?  Thanks! 

Edited by Stenrik
Typo

Share this post


Link to post
Share on other sites
Posted · Co-Polyester + PVA?

I haven't tried ColorFabb Co-Polyester, but Ultimaker CPE and PVA are totally a workable and supported combination, per the chart here: https://ultimaker.com/en/resources/49799-material-compatibility 

Ultimaker CPE+ isn't supported with PVA (it uses a high bed temperature), but regular Ultimaker CPE is supported with it. In theory ColorFabb Co-Polyester is probably okay, but I haven't tried it. If you're going to try a combination with PVA that you're not sure about...keep an eye on the print when testing it out.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!