Jump to content
Ultimaker Community of 3D Printing Experts

Modify TinkerGnome source code to swap round hotend heater 0 and 1


Octocom
 Share

Recommended Posts

Posted · Modify TinkerGnome source code to swap round hotend heater 0 and 1

Hey all,

 

My hotend heater blew the other day and since then no matter what I change multiple times temperature sensors or heaters (30w,35w and 40W) with base pid settings for each watt the autotune always fails by over shooting over 20c.  I have tried all suggestions on the forums for pid, but there is a consistent overshoot speed.

 

I think my mosfet might be damaged, so I want to build a firmware using heater and temperature device 2 as default. If it is the mosfet at least I can use the 2nd connection as a redundancy so I don't have to buy a new control board. 

 

Can anyone advice the source code reverences need to be changed? and would this just be in the Configuration or Configuration_adv as well?

 

Luke

  • Link to post
    Share on other sites

    Posted · Modify TinkerGnome source code to swap round hotend heater 0 and 1
    2 hours ago, Octocom said:

    I want to build a firmware using heater and temperature device 2 as default

     

    I think, swapping the pin numbers in "pins.h" is all what is needed.

     

    In "pins.h" go to the section "MOTHERBOARD == 72" and swap the pin numbers between

    HEATER_0_PIN  /  HEATER_1_PIN

    TEMP_0_PIN / TEMP_1_PIN

     

    https://github.com/TinkerGnome/Ultimaker2Marlin/blob/geek_mode/Marlin/pins.h#L1192

     

    good luck!

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...