Jump to content
Ultimaker Community of 3D Printing Experts

Printing with .25 nozzle


Recommended Posts

Posted · Printing with .25 nozzle

Hi Everyone,,

 

tried to make my first print with .25 nozzle, Im using nGen printing at .10 Layer height with 3 perimeters and 50% infill but my prints are Britle Temp 215 can anyone shine a light were Im going wrong speed is low

  • Link to post
    Share on other sites

    Posted · Printing with .25 nozzle

    I'm surprised they are brittle.  I would lower the fan.  Listen to it and make sure it sounds like 1/4 as loud.  It also helps to enclose the machine but lowering the fan should be enough.

     

    Usually when I use .25 or .15 nozzle I am printing very small things so I also print multiple objects to give one time to cool down (while the other is printing).  But with nGen you don't need so much cooling so I suggest you just lower the fan quite a bit.

  • Link to post
    Share on other sites

    Posted · Printing with .25 nozzle

    Yeah, I also find nGen quite brittle using the 0.25 nozzle. I would probably increase the temp a bit, Turn off Z-Hop and avoid printed parts when travelling to reduce travel times and keep heat on the part. nGen doesn't really have the best bond to itself which means that the strength between each wall and layer is not hugely strong. Using a 0.25mm nozzle means you have even less strength cos the print lines are so small. 

    Keeping the part as warm as possible without affecting your print quality is the best solution. So maybe up the temp and play with retraction, travels and combing to reduce oozing.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 10 replies
    ×
    ×
    • Create New...